BLAZE BLZ-ELEC-21 Manuel Du Propriétaire page 10

Pedestal Models
Reference the figure below when installing your pedestal electric grill.
Using a Phillips-head screwdriver, remove the 4 screws and bumpers on the bottom of the grill.
1.
Discard the bumpers. Align the electric grill onto the top of the post assembly. Using the same 4 screws,
fasten the electric grill to the post assembly.
The post assembly base must be securely fastened to a stable, level surface using the lag screws
2.
and shields (not supplied) to ensure the grill remains fixed and upright at all times.
Side Shelf Instructions.
1.Using 3 screws, align and fasten each shelf bracket to the side of the grill.
Holding the shelf horizontally, align the slots on the shelf with the pin on the bracket and slide shelf into
2.
position.
Repeat for the opposite side.
3.
Note* The shelf is a 2-position shelf: 1. Raised and 2. Lowered
Important: BEFORE USE, the grill base must be securely fastened to a stable, level surface
to ensure the grill remains fixed and upright at all times.
Locate the patio mount base in the planned grill location and mark the 4 holes. Drill the marked holes to a
1/2" diameter x 1 1/2" depth. Insert the lag shields (not supplied) into the holes, ensure that they are flush
with the ground.
Align the holes on the
over the lag shields
ground. Secure the
screws (not supplied)
driver.
Installation and Assembly cont.
A. Bolt holes for bolting
pedestal to the ground
patio mount base
(not supplied) in the
base with the lag
using a 7/16" nut
A. Bolt holes for bolting
pedestal to the ground.
10