Ec Declaration Of Conformity; Cooling Down - Black & Decker KD350 Mode D'emploi

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

ENGLISH

the speed switch or the forward/reverse when your

drill is operating.

USING YOUR DRILL

again and release. While your drill is in operation, do

not touch the chuck.

HANDY HINTS

• Fit the correct size and type of drill or screwdriver bit.

• Set the correct drill speed.

• Always hold your drill using the handle and the

side handle.

• Always hold your drill at right-angles to your work.

to the hammer mode

hammer switch to the drill mode

• Set the forward/reverse switch to the correct direction.

• Never change the direction of rotation when your

drill is in operation.

• After use, remove the drill bit and gently tap the side

of the chuck with a soft-faced hammer to remove

the dust. This will extend the life of the chuck.

COOLING DOWN

If your drill becomes too hot in use, set the speed

control to its highest setting and allow your drill to

operate without load for 2 minutes.

To switch your

drill on, depress

the on/off switch.

Your drill stops

when the on/off

switch is released.

If continuous

operation is

required, depress

the lock-on

button while the

on/off switch is

depressed.

To stop your drill

when operation is

continuous, depress

the on/off switch

When drilling

wood and metal,

set the hammer

switch to the drill

mode

When drilling

masonry, set the

hammer switch

. When screwdriving, set the

OVERLOAD

Never use excessive force when using your drill. Too

much pressure can reduce the speed of your drill and

reduce its efficiency. This can result in an overload

which can cause damage to the motor of your drill.