Know Your Unit; Assembly Instructions - Cub Cadet CC5090 Manuel De L'utilisateur

KNOW YOUR UNIT

Oil Fill Plug
On/Off Stop
Control
Cub Handle
EZ-Link™
Shaft
Cutting Attachment
Shield
Air Filter
Cutting
Attachment
Brushcutter
Blade
INSTALL AND ADJUST THE D-HANDLE
1. Remove the screws and
bottom clamp piece that
were installed on the Cub
handle for shipping.
2. Place Cub handle over
the shaft housing and
onto the bottom clamp
(Fig. 1). Place it a
minimum of 6 inches
(15.24 cm) from the end
of the shaft grip.
3. Start screws with a large
Flat-head or T-25 Torx screwdriver. Do not tighten until
you make the handle adjustment.
4. If it was pre-installed, loosen the screws on the Cub
handle just enough to move the Cub
handle.
5. While holding the unit in the
operating position (Fig. 2), move the
Cub handle to the location that
provides you the best grip.
6. Tighten the clamp screws evenly,
until the Cub handle is secure.

ASSEMBLY INSTRUCTIONS

Spark
Muffler
Plug
Starter
Shaft Grip
Throttle
Control
Shoulder
Strap Loop
Choke
Lever
Cover
Line
Cutting
Blade
(4) Screws
D-Handle
Minimum
6 inches
(15.24 cm)
Fig. 1
Fig. 2
INSTALL THE HARNESS
1. Push the strap through the center of the buckle.
WARNING: Always use the shoulder harness when
using the cutting blade to avoid serious personal
Fuel
injury.
Cap
2. Pull the strap over the cross bar and down through the slot
in the buckle (Fig. 3).
Rope
Grip
3. Put the harness on over head and onto shoulder. Snap it
on to the support fitting (Fig. 4).
4. Adjust length to fit the operator's size. Pull tab to lengthen,
pull strap to shorten (Fig. 5).
Spark
Plug
Primer
Bulb
Fig. 3
Fig. 5
REMOVE AND INSTALL THE CUTTING ATTACHMENT SHIELD
WARNING: The cutting attachment shield should
NOT be installed when operating the unit with a
blade. Remove the cutting attachment shield
before removing or installing the blade.
Remove the cutting attachment shield when using the unit
as a brushcutter
Remove the cutting
attachment shield from the
shield mount by removing the
three (3) screws with a flat
Bottom
blade screwdriver (Fig. 6).
Clamp
Store parts for future use.
Install the cutting
attachment shield when
using the unit as a grass
trimmer
WARNING: To avoid serious personal injury, the
cutting attachment shield MUST be in place at all
times while operating the unit as a grass trimmer.
Install the cutting attachment shield on the shield mount by
inserting the three (3) screws into the shield mount. Tighten
securely with a flat blade screwdriver (Fig. 6).
REMOVE THE CUTTING ATTACHMENT AND INSTALL THE
CUTTING BLADE
NOTE: To make cutting blade removal and installation easier, place
the unit on the ground or on a work bench.
Remove the Cutting Attachment Shield
See Remove and Install the Cutting Attachment Shield.
4
Support Fitting
Fig. 4
Cutting
Attachment
Shield
(3) Screws
Gear Housing
Shield Mount
Fig. 6