BST MX35USB Mode D'emploi page 3

freezes, restart the application software or the computer OS, or unplug the mixer and then plug it in again.
• Use an AB type USB cable. USB 3.0 cable cannot be used.
• Before connecting the computer to the USB 2.0 terminal, exit from any power-saving mode of the
computer (such as suspend, sleep, standby).
Controls and Functions
1. MIC/LINE Input jacks
For connection to a microphone, an instrument, or an audio device. These jacks support both XLR and
phone plugs.
2. CLIP LED
Lights when the volume of input sound is too high. If it is lit, turn the GAIN knob to the left to lower the
volume.
GAIN knob
Determines the basic volume for channel 1. Adjust this knob so that the CLIP LED flashes briefly when
singing or playing the loudest.
3. USB PLAYBACK TO CH3-CH4 switch
If the switch is turned on, the sound from the computer is assigned via the USB 2.0 terminal to channel 3/4.
4. +48V phantom switch / +48V LED
When this switch is turned on, the +48V LED lights and DC +48 V phantom power is supplied to the XLR
plug on MIC/LINE input jack. Turn this switch on when using a phantom powered condenser microphone.
NOTE: Be sure to leave this switch off if you do not need phantom power. Follow the important precautions
below, in order to prevent noise and possible damage to external devices as well as the mixer if you turn
this switch on. Be sure to leave this switch off when you connect a device to channel 1 that does not
support phantom power. Make sure to turn this switch off when connecting/ disconnecting a cable to/from
channel 1.
Slide the fader on channel 1 to minimum before turning this switch on /off.
©Copyright LOTRONIC 2016 3 MX35USB