FALMEC Cielo 120 UM Livret D'instructions page 22

Do not use abrasive products. All the above operations must be performed after having dis-
connected the appliance from the mains power supply.
L
WARRANTY
The new equipment is covered by warranty.
The warranty conditions are provided by the distributor.
The manufacturer is not liable for any inaccuracies in this booklet resulting from printing or
transcription errors. The manufacturer reserves the right to modify its products as it consid-
ers necessary or in the interests of the user, without compromising their essential safety and
operating characteristics.
M
RANGE HOOD ASSEMBLY
Fig. A
1) Remove the rubber caps and turn the 4 "V2" metric screws, loosening them without
removing them. These screws keep the pre-assembled "SP" support on the hood.
2) Turn the hood over, after putting a protective sheet under it.
Fig. B
Remove the pre-assembled "SP" hood support as shown in the figure.
Fig. C
1) Fix the "SP" support to the ceiling using 6 "V3" screws and the supplied plugs. Make sure
the "CAI" supply cable does not remain crushed.
2) Check the tightness and solidity of the installation.
Fig. D
1) Lift the hood near the "SP" support. Disconnect the hood's power supply and make the
electrical connection between the "CAI" system supply cable and the "CAC" hood sup-
ply cable, using terminal board "M" in compliance with current standards.
2) Move the hood sideways and hook it to the 4 "V2" metric screws of the "SP" support.
When the hood is in place, fully tighten the 4 "V2" screws. Tighten the 4 "V4" safety
screws to further lock the hood body to the "SP" support.
Fig. E
Fasten the "VC" glass sleeve to the hood using 4 "V5" knurled metric pins and connect the
keyboard terminal to the hood electronics as shown in the figure.
Fig. F
Hook them to hood door "P" and side components "EL" as shown in the figure.
Fig. G
Fasten the hood to components "EL" and carbon filters "FC", as shown in the figure (pay
ATTENTION to the assembly direction of the filters: see figure G2).
Fig. H
Insert the grease-trapping metal filter kits with zeolite filters as shown in the figure. Close
door "P" and switch on the hood power supply complying with the current standards.
20