FALMEC Cielo 120 UM Livret D'instructions page 20

To turn off the hood, first select the 1st speed, then press that key again.
6: Light – Associating a radio control
Light: By shortly pressing T6 key, you can turn the light on and off. T6 key will light up if the
light is on.
Associating a radio control: Applying prolonged pressure on T6 key with the motor and light
off will enable the remote binding mode. T6 key will flash for a maximum of 10 seconds. Dur-
ing flashing, at least one radio control key must be pressed. The function will deactivate at
the end of the 10 seconds, or earlier if a compatible remote control is detected.
Key pressure management :
Prolonged pressure = finger on key for at least 3 seconds, the function activates during
pressure.
Non-prolonged pressure = finger on key for less than 3 seconds, the function activates when
it is released.
Radio control: Place the device far from sources of electromagnetic waves which could
interfere with the hood electronic functions.
Maximum operating distance 4 metres. This distance may vary in defect based on the elec-
tromagnetic interference of other devices.
Radio control operation
Light Key By pressing the Light key, the light is switched on/off
Key ' - ' By pressing the '-' key, the motor speed is decreased. If the 1st speed is active, by
pressing the '-' key, the motor is turned off.
' + ' Key
If the motor is turned off, by pressing the '+' key, the motor is enabled at the 1st speed. If the
motor is running, by pressing the '+' key, the motor speed is increased to the top.
Timer Key If the motor is active, by pressing the timer key the timer function is enabled/
disabled
Code Change
(only in case of malfunction)
Press the "Luce" (Light) key together with the "Timer" key of the radio control until the blue
LED begins to slowly flash. If the "-" key of the radio control is pressed within 5 seconds, the
new code will be generated and memorized. Memorisation is confirmed by 3 short flashes
of the LED.
To return to the default code, press the "-" and "+" keys together for over 5 seconds. The de-
fault code memorization of the default code will be signalled with 3 short flashes of the LED.
henever a new code is generated or the default code is set in the remote control, it is nec-
essary to also carry out the previously described procedure related to Associating a radio
control (Light Key of the push button control panel).
G
METAL FILTERS AND CARBON FILTERS
1. METAL FILTERS
To access the metal filters open the panel P (see fig. G1).
To remove the grease-trapping metal filter, use handle "A" (see figure G1 – detail 1-2).
18