Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Disassembling the rangetop
Only necessary if an orifice is dropped
inside the rangetop
9 CAUTION
Shut off the gas supply to the appliance prior to
disconnecting the electrical power.
To disassemble the rangetop
1. To facilitate the removal of the spill tray, remove the T-
20 torx screws in the front face of the island trim or
backguard.
2. Disconnect the igniter. Carefully pull up on the burner
base.
a
b
c
d
5. Carefully remove each burner pedestal.
6. Remove the spill trays by rotating the trays up and out
the back.
7. Remove the heat shield on some models. Some
models have a double-width shield that extends under
the adjacent spill tray.
a. Burner base
b. Electrode
c. Igniter housing
d. Igniter wire
Setting the STAR
valve screws
Only necessary for converting propane
gas units from 10,000 ft to 10,200 ft.
A flat-head screwdriver with an
1/8" [3.0 mm] wide, .020"
[0.50 mm] thickness tip
(included) is used to adjust the
valve screws.
1. Remove the knob from the valve stem by slowly
pulling knob straight out, away from the control panel.
2. Remove the bezel-mounting
screw located to the right of
the valve stem, using a T-20
torx screwdriver.
3. Insert a 1/8'' flat-
blade screwdriver
into the hole of the
bezel mounting
screw. Access to the
valve screws through
clearance hole in the
spark module. You
should feel the
engagement of the
screwdriver and the
valve screw.
®
burner
Page. 9
Publicité
Table des Matières
