Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
4. Adjust the valve screw by turning the valve screw
th
about an 1/8
turn clockwise to reduce simmer flame
size. Turn the screw counter-clockwise to make the
simmer flame larger. Adjust the valve screw as little as
required to reach satisfactory simmer results. Due to
normal fluctuations in gas pressure, over-adjustment
of valve screw may affect flame stability.
5. Perform a gas leak test of each orifice and associated
supply tube fittings. See "Checking for gas leaks" on
page 14. Leak-checking should occur after the orifice
conversion is complete, and before the burner is
reassembled and tested.
Changing the broil orifice, on
GAS ranges only
Only necessary for converting propane
gas units from 10,000 ft to 10,200 ft.
9 CAUTION
After the replacement of the broiler orifice, and
before reassembly of the back panel and backguard to
the range, perform a brief gas leakage check of the
orifice and associated fittings, per the "Checking for
gas leaks" section of these instructions.
NOTE: Dual Fuel ranges have electric ovens and do not
have a broil orifice.
Change only the following oven broil orifices. All other
orifices shall remain the same.
48'' Pro Harmony and 36'' Pro Grand
(PRL48xWxH and PRL36xWxG)
Main oven broil
•
48'' Pro Harmony
•
36'' Pro Grand
Page. 10
Removing the backguard assembly
1. Use a T-20 torx screwdriver to remove the screws from
the front and rear panel of the backguard assembly.
2. Carefully lift the backguard assembly from the range.
Orifice no.
1.20 mm
(120)
Publicité
Table des Matières
