Electrical Connections - C-LITE C-TR-B-BT Serie Instructions D'installation

INSTALLATION INSTRUCTIONS
C-TR-B-BT LED Series

ELECTRICAL CONNECTIONS

Fixture is equipped with either a universal volt driver 120-
277V or a 120-347V driver.
NOTE: Make sure voltage range of fixture is compatible
with supply voltage.
PHASE TO NEUTRAL WIRING 120/277/347V
Using customer supplier 90C minimum rated wire connectors,
make the following connections.
1. Connect supply ground to fixture ground (green) lead
or terminal block position.
2. Connect supply common to fixture neutral (white) lead
or terminal block position..
3. Connect supply Vin to fixture hot (black) lead or
terminal block position.
Tuck all wires carefully into wiring chamber ensuring that no
wires are pinched.
PHASE TO PHASE WIRING 208/240V
1. Connect supply ground to fixture ground (green) lead
or terminal block position..
2. Connect supply L1 (Hot) to fixture neutral (white) lead
or terminal block position..
3. Connect supply L2 (Hot) to fixture hot (black) lead or
terminal block position..
Tuck all wires carefully into wiring chamber ensuring that no
wires are pinched.
DIMMING
1. Grey or pink (-) and violet (+) leads are for 0-10V,
DALI or DEXAL dimming systems. Cap off leads if not
used.
NOTE: For dimming connections, use Class 1 wiring
methods only.
http://lighting.cree.com/warranty
Document:
LPN00606X0001A1_A
Created By:
TMT
FCC NOTICE ONLY
CAUTION: Changes or modifications not expressly approved could
void your authority to use this equipment.
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits
for a Class A digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area
is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
CAN ICES-005 (A)/NMB-005 (A)
| 866.924.3645
Date:
8-19-2021