How The Pet Fencing System Works; Installing The Pet Fencing System - EYENIMAL Classic Dog Fence Guide D'utilisation

Diagram 3
Nylon strap
● How the pet fencing system works
You can define your dog's play area by installing a wire, called antenna wire, around the authorized perimeter. This wire placed on the ground,
buried or raised on an existing fence carries a radio signal from the transmitter.
When your dog, wearing a receiver collar, approaches this wire, he is warned by beep sounds that he is too close to an area where he is not
allowed; then if he carries on, static correction will be emitted by the collar. Your dog will have to leave the unauthorized area to stop the static
correction and beep sounds.
An unlimited number of receiver collars can be used with one transmitter: you can keep as many dogs as you wish safely in the same area.
The CLASSIC DOG FENCE pet fencing system has been designed to give you complete satisfaction with an antenna wire with a maximum
length of 1500 Ft. If a longer antenna wire is used, the pet fencing system will still work, but the warning and static correction zones will be
markedly reduced.
● Installing the pet fencing system
 Transmitter
The transmitter must be installed indoors in a dry location: the transmitter can withstand changes in temperature but will be damaged by water.
Install the transmitter in a garage or garden shed near an electrical outlet.
 Antenna wire
For the system to operate, the wire must be connected to the transmitter and form a continuous loop from the transmitter and back again. The
outward and inward wires must be spaced 6 Ft apart to avoid cancelling the signal.
20 AWG or 15 AG wire can be used (you can combine several wire sections).
The wire sections recommended depending on the length of the system are as follows:
 for less than 1500 ft of antenna wire: 20 AWG
 from 1500 ft to 2700 ft of antenna wire: 20 AWg
From the transmitter, unroll the wire around the perimeter you wish to protect. To run the wire from your garage or garden shed, pass it through
a window, door or similar.
Indicator light:
On/Off indicator
+
battery level indicator
area where the switch magnet is located
This magnet allows you to switch On/Off the collar and
to select the level of static correction
- 2 -
symbol:
Magnetic key
(magnet)