Parker PNEUDRI Maxi DXE Série Guide D'utilisation page 27

DRYFIL ® DESICCANT SAFETY DATA
domnick hunter DRYFIL
HAZARDOUS" for transportation. It is formed into spherical particles using clay binders, buff coloured, non-
volatile and non-flammable.
HANDLING PRECAUTIONS
The product may contain some dust, if so an orinasal dust respirator should be worn when handling the
product. By providing adequate ventilation the dust levels in the working atmosphere should be maintained
below 10mg/m , the recommended maximum level for nuisance dusts.
3
The product is a powerful desiccant and will dry out the atmosphere, eyes, nose and mouth.
Eyes and skin coming into contact with dust or product should be washed with copious amounts of clean
water. If symptoms develop consult a doctor.
Any spillage should be swept away immediately because the spheres roll freely and it is very easy to slip if
walked on.
TRANSPORTATION AND TARIFFS
DRYFIL ® is classified as "NON-HAZARDOUS" for transportation.
STORAGE
The product is stable indefinitely at ambient temperature. It will, however, lose its desiccant and adsorption
properties when heated to 900˚C (1652˚F).
This product evolves heat on contact with moisture. Ideally, it should be stored in a clean dry warehouse, in the
original package, on pallets.
It should not be stored with materials subject to catalytic decomposition.
FIRE AND EXPLOSION HAZARD
The product is non-flammable. Any fire should be fought by means appropriate to the material causing the fire.
Contact with water will cause the evolution of heat and may thus generate pressure in a confined space.
HANDLING AND DISPOSAL OF SPENT MATERIAL
This information is dependent upon the application. Great care should be exercised with spent material. As a
powerful adsorbent, the product may retain hazardous or flammable components from the process fluid. The
process vessels should be purged of contaminants before discharge, normally after regeneration. To remove
residual vapours the spent product should be thoroughly drenched with water during or after discharge.
CAUTION! HEAT WILL BE GENERATED!
It is also possible that the product may contain decomposition, polymerisation or trace contaminants from the
process fluid and should be treated accordingly. Dust may have been created in service.
The product should be disposed of into a licensed land fill site.
This reply is based on information which was available at this moment in time. To the best of our knowledge
we believe this information to be correct at the time of printing.
® desiccant is a high performance Zeolite Molecular Sieve which is "NON-
25