Installing Your System Pneumatically; Pneumatic Connections - Parker PNEUDRI Maxi DXE Série Guide D'utilisation

C) INSTALLING YOUR SYSTEM PNEUMATICALLY (See Figure 2)
2
8
6
7
4 3
5
9
8
1
Figure 2 - TYPICAL SINGLE BANK INSTALLATION
Install the dryer where the ambient air is as clean as possible and where the air temperature will never exceed
the dryers temperature limits.

PNEUMATIC CONNECTIONS

Connect the Inlet (1) and Outlet (2) compressed air lines to the valve housings marked Inlet and Outlet, ensuring
the protective dust covers fitted to the flanges on the PNEUDRI are removed prior to connection.
MANIFOLD & DRAINS
On installations with fabricated manifolds, an automatic drain valve must be fitted at the lowest point of the
inlet manifold to prevent condensate from entering the dryer.
16