Technical Specifications - Parker PNEUDRI Maxi DXE Série Guide D'utilisation

2. TECHNICAL SPECIFICATION
A) GENERAL
Type:
Model:
Outlet Dewpoint:
Air Quality:
(dirt/water/oil):
Maximum Operating Pressure:
Minimum Operating Pressure:
Maximum Inlet Temperature:
Minimum Inlet Temperature:
Regeneration:
Nominal pressure drop
across desiccant bed:
Standard Electrical Supply:
Controls:
Controller:
Noise Level (Average):
Media
Material:
Construction:
Pre filtration:
After filtration:
Heatless
DXE/DXS
13.0 bar g (189 psi g) - optional
Pressure Swing Adsorption (PSA)
[Air Purge Principle]
110/230V/1ph/50Hz/60Hz
DXE/DHE - PNEUDRI electronic - microprocessor with integrated display
DXS/DHS - PNEUDRI electronic - SMART
High tensile extruded aluminium coated with Alocrom anti-corrosion
protection and paint finished with an abrasion resistant dry powder epoxy
coating.
PNEUDRI is constructed from extruded aluminium sections connected
together by high tensile bolts i.e. desiccant filled columns are contained
between an upper and lower manifold. The configuration varies between
the heatless and heat regenerative models as shown in figures 1 & 2
9
Heat Regenerative
DHE/DHS
-40°C (-40°F)
-70°C (-100°F) - optional
ISO 8573.1 Class 1.2.1
Class 1.1.1 optional
10.5 bar g (152 psi g)
4 bar g (58 psi g)
50°C (122°F)
5°C (41°F)
Thermal Swing Adsorption (TSA)
[Heat & Air Purge Principle]
140 m bar (2 psi)
400V/3ph + neutral/50Hz/60Hz
Control equipment 24V ac.
<75db (A)
Desiccant
Grade AO/AA OIL-X filters
Grade AR OIL-X filter