Moulinex mini space cyclonic Mode D'emploi page 16

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 1
• Place a new foam microfilter* (9) into its housing - Fig.39
EN
• Make sure that the foam microfilter is correctly positioned* (9) before putting the dust container
back(10).
CLEANING THE VACUUM CLEANER
• Wipe the body of the appliance and the accessories with a soft and damp cloth, then dry.
• Wipe the cover with a dry cloth - Fig.40.
• Do not use detergents, chemical or abrasive products.
VI. TROUBLESHOOTING
Important: s soon as you notice that your vacuum cleaning is not working as well as it should be and
before carrying out any checks, switch it off using the On/ Off button.
IF YOUR VACUUM CLEANER WON'T START
• The appliance has not got any power: check that the appliance is correctly plugged in.
IF YOUR VACUUM CLEANER DOESN'T HAVE ANY SUCTION POWER
• n accessory or the flexible hose is blocked: unblock the accessory or the flexible hose.
• Check that the dust container (10) is correctly fitted.
• Check that the cover is properly closed.
IF YOUR VACUUM CLEANER HAS LESS SUCTION POWER, MAKES A LOT OF NOISE,
WHISTLES
• n accessory or the flexible hose is blocked: unblock the accessory or the flexible hose.
• The dust container is full: empty it (see chapter CLE NING ND M INTEN NCE).
• The filter system is saturated: clean the (H)EP filter cassette (11) (see chapter CLE NING ND M IN-
TEN NCE).
If the problem persists, change the filter system (see chapter CLE NING ND M INTEN NCE).
• The adjustable manual power switch for the nozzle is open: close the adjustable manual power switch.
• Check that the dust container (10) is correctly placed in the dust tray compartment (6).
IF IT IS DIFFICULT TO MOVE THE NOZZLE
• Turn the nozzle regulator button to reduce the power.
• Check that the position (retracted brush / advanced brush) of the all-floor nozzle (19) is the right one for
the floor surface being cleaned.
IF THE POWER CORD DOES NOT REWIND COMPLETELY
• The power cord is slowed down when rewinding: pull the power cord out again and press the power
cord rewind button.
If a problem persists, take your vacuum cleaner to your local Moulinex pproved Service Centre.
Check the list of Moulinex pproved Service Centres or contact Moulinex customer services (you can
find contact details on the last page).
GUARANTEE
• This appliance has been designed for domestic use only; the manufacturer will accept no responsibility
in the event of any inappropriate use or failure to comply with the instructions and the guarantee will
cease to apply.
• Read the instructions for use carefully before using your appliance for the first time: any use of the ap-
pliance which does not conform to these instructions will release Moulinex from any liability.
Depending on models: either equipment specific to certain models or available as an optional accessory.
11

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Mo332101

Table des Matières