Connecting The Gas Cylinder - BURNHARD NERO Mode D'emploi

CONNECTING THE GAS CYLINDER

Fire and explosion hazard
ATTENTION: Never connect new or not completely empty gas cylinders if
there are ignition sources in the immediate vicinity. Never smoke.
The following items are included in delivery: They comply with the norm ap-
plicable in the state where the grill is delivered:
• Gas hose (pre-assembled): CE-approved hose line of sufficient length
(max. 1.5 metres) to allow kink-free installation.
• Pressure reducer (pre-assembled on the gas hose): Fixed and CE-appro-
ved pressure reducer according to DIN EN 16129, max. 1.5 kg / h, operating
pressure 50 mbar, suitable for the gas bottle used.
1. Screw the cap nut at the end of the hose onto the thread on the gas mo-
dule. Tighten the cap nut by hand.
2. Check whether the cap nut of the hose is screwed on tightly to the pres-
sure regulator (pre-assembled). If necessary, tighten the cap nut with a
wrench.
3. Unscrew the protective cap from the thread on the gas cylinder. Screw
the cap nut on the pressure regulator onto the thread on the gas bottle.
Tighten the cap nut by hand. Don't use tools to avoid damaging the seal.
42