Technoline WS6447 Mode D'emploi page 15

TO READ MAXIMUM-MINIMUM IN-OUT TEMPERATURES AND HUMIDITIES
At normal time display mode, press MEM once to view the maximum indoor-outdoor temperatures
and humidity records with "MAX" icons appearing on the display. Press again to view the minimum
indoor-outdoor temperatures and humidity and the "MIN" icons appearing on the display.
When the maximums or minimums are displayed, press and hold the MEM to reset both records and
it will start to record the maximums and minimums again.
IF YOU LOSE THE OUTDOOR TEMPERATURE AND HUMIDITY
When the outdoor temperature and humidity digits show '---", the wireless transmission is either
interrupted or lost. Press and hold the  / CHANNEL button to start searching for the signal from the
outdoor transmitter with the
If you continue to lose the outdoor temperature and humidity display, which could happen in extreme
cold weather, try placing the transmitter in a different location until you have smooth transmission of
temperature / humidity data.
HOW TO SYNCHRONIZE YOUR WEATHER STATION WITH ANOTHER OUTDOOR
TRANSMITTER
1. At the back of your weather station, Press  /
temperature and humidity.
2. Press and hold  /
another outdoor transmitter at Channel 2.
3. Slide open the battery door of your second transmitter, slide the switch to the middle position
marked with 2, then insert two AAA batteries into the battery compartment by observing the
correct +/- polarity. Replace the battery cover.
4. The outdoor temperature and humidity of your second transmitter will appear on the LCD together
with icon within few seconds. If the data still does not appear, take out and reinstall batteries to
your second transmitter once.
5. To synchronize your weather station with a third outdoor sensor, repeat the same step by choosing
on your weather station and select 3 on the switch on your third transmitter.
AUTO SCROLLING THE OUTDOOR TEMPERATURE AND HUMIDITY OF DIFFERENT
TRANSMITTER
Press  /
one at a time until the
temperature and humidity of different outdoor transmitter will be displayed for few seconds alternately
with , , .
To stop the auto scrolling, press  /
and humidity of the
LOW BATTERY INDICATION OF YOUR OUTDOOR TRANSMITTER
The icon will appear to indicate the battery level of your outdoor transmitter is getting low. You may
need to replace the batteries of your outdoor transmitter with new ones.
Extreme cold weather (e.g. below 14 °F) will also cause low battery voltage.
Problem
LCD is blank
flashing.
until the icon blinks, your weather station is searching for the signal of
transmitter, the
Solution
1. Replace fresh batteries in your weather station.
2. Make sure the AC/DC adaptor is plugged into an working AC
outlet properly.
3. Make sure the DC jack is plugged in to the weather station
properly.
once.
icon flashes with a short beep tone. Then the outdoor
once to go back to constant display of the temperature
icon remains static on the display.
EN 6
icon appears near your outdoor