Polaris GLACIER III Manuel D'installation page 11

"GLACIER III" PLOW FRAME
KIT PN 2878228
READ AND UNDERSTAND THE FOLLOWING OPERATING INSTRUCTIONS TO
AVOID SEVERE PERSONAL INJURIES OR DEATH.
COMPLIANCE WITH THESE SAFETY MEASURES WILL ALSO ENSURE THAT
YOUR SNOW PLOW WILL GIVE YOU MANY YEARS OF GOOD USE.
RE-TORQUE ALL BOLTS AND NUTS AFTER FIRST 1/2 HOUR OF USE.
• DO NOT EXCEED 5 MPH WITH BLADE INSTALLED.
• OPERATE WITH EXTREME CAUTION ON SLOPES, GRADES, AND ROUGH TERRAIN.
• KEEP AWAY FROM BLADE AND MOVING PARTS DURING OPERATION.
• WHEN PLOWING SNOW OR DIRT INTO A PILE START BACKING UP BEFORE RAISING THE BLADE.
• DO NOT RAM THE BLADE INTO THE PILE. ** SLOW DOWN BEFORE HITTING PILE .**
• BEWARE OF POSSIBLE HIDDEN OBJECTS UNDER SNOW.
• READ BLADE OWNER'S MANUAL, ATV OPERATOR'S MANUAL, AND SAFETY DECALS BEFORE
OPERATING.
• ALWAYS WEAR APPROPRIATE PROTECTIVE CLOTHING AS RECOMMENDED IN ATV OPERATOR'S
MANUAL.
• DO NOT ALLOW RIDERS ON BLADE OR ATV.
• KEEP BYSTANDERS AWAY FROM BLADE AND ATV WHILE MOVING.
• BEFORE ADJUSTING BLADE ANGLE: STOP ATV ENGINE, SET AND LOCK BRAKES, RAISE AND LOCK
BLADE IN UP POSITION. DO NOT ATTEMPT TO RAISE BLADE BY HAND.
• BEFORE ADJUSTING BLADE HEIGHT: LOWER BLADE TO THE DOWN POSITION.
• WHEN BLADE IS NOT IN USE, STOP ATV ENGINE, SET AND LOCK BRAKES AND LOWER BLADE TO
DOWN POSITION.
• POLARIS RECOMMENDS TO REMOVE THE BLADE AND THE PLOW FRAME BEFORE TRAIL RIDING.
7515095
A-7515095 Rév. A
- 3 -
Imprimé en Chine / Printed in China