Publicité
Les langues disponibles
Les langues disponibles
Operating Instruction cable cutter KS1
Content
1.
Technical data
2.
Intended use
3.
Operator information
4.
Handling
1. Technical data
Weight: approx. 100g
Length: approx. 150 mm
Year of construction: 2010
2. Intended use
The cable cutter KS1 is only for cutting and dismantling fine copper wiring - and aluminium-conductors. Therefore the straight
blade-section is for cutting through wires with cross sections between 0,5 to 6 mm
sections up to 20 mm
.
2
No usage other than that mentioned above is intended and therefore permitted. The instructions in this ma-
nual must be followed precisely.
3. Operator information
This instruction manual has always to be available when using the tool. Take care that only persons who have acquainted them-
selves with this manual before processing and who have understood it are allowed to work with the tool.
4. Handling
Cutting
Formed cable cutter for cross sections up to 20 mm
Straight blade-section for cutting through wires with cross sections between 0,5 and 6 mm
Micro-serrations on this part of the blade prevent the cable from slipping.
Dismantling up to 50 mm
Locking screw joint.
The joint can be re-adjusted by opening the marked black cover.
Ergonomic grip design to reduce the cutting force.
Plastic without cadmium and heavy metal.
Absorber for heavy cuts.
Safety box for storing of the cable cutter safely.
For safety reasons push the cable cutter as far into the holder as it will go.
With holding clip to hang on a belt or a wall.
2
Cable cutter KS1 2692-0000-10-00
2
2.
.
2
and the formed cable cutter for cross
.
2
Publicité
