Product Features - Corradi Ermetika Manuel Utilisateur

PRODUCTS FEATURES

PRODUCT FEATURES

ERMETIKA
The temperature inside the protection hood can reach very high values, if exposed to direct sunlight
during the summer. This may result in bonding of the fabric if the awning is not handled for long
periods. It is recommended to open and close the awning on a frequent basis to avoid this problem.
If the fabric is rolled up for long periods creases and wrinkles may appear on the fabric. The fabric is
made of PVC and its nature is not comparable to a glass. It is necessary to keep the awning stretched
for at least 48h to soften creases and wrinkles.
In case of installation in areas affected by dust and wind (e.g. beach facing the sea) it is possible that
the fabric may be damaged losing the transparency due to the combined action of wind and sand.
To maintain a good efficiency on the awning and the locking device it is necessary to maintain the
vertical runners clean as shown in the maintenance chapter.
Make sure there are no obstructions that may impede the orderly movement of the awning. This
may cause malfunction of the locking devices of the awning.
If there is ice/snow runners should be cleaned thoroughly before operating the awning.
26 of 76
CORRADI SPA -
USER MANUAL - ERMETIKA®
NON COMPLIANCE/ DEFAULT
09.05.2013