Artsound R4 Mode D'emploi page 43

Network uses a time signal sent from the Frontier
Silicon Internet radio portal when in any net-
work-connected mode.
1. Select Update from DAB, Update from FM,
Update from Network or No update.
2. If you are updating from the network, set your
time zone.
3. If your country uses daylight saving, the auto-
matically updated time from the network may be
wrong by one hour. When daylight savings are
in effect (during the winter), turn on the Daylight
savings option to rectify this.
Note that if you are updating the time from DAB
or FM, the Daylight savings option has no effect
on the clock's time.
R4 will auto-update from the selected source
when time information is available.
Manual set
If you set No update, the wizard now prompts you
to set the time and date manually.
The date and time are displayed as dd-mm-yyyy
and hh:mm AM/PM with the first value, dd, active
(flashing).
Adjust each value with the Select control.
As each value is set, the next value becomes
active and flashes.
3.1.3 Network
R4 is compatible with all common network pro-
tocols and encryption methods, including Wi-Fi
Protected Setup (WPS).
To connect R4 to your network, you need a Wi-Fi
wireless router, together with password key if
set Select WLAN region/country >Wi-Fi network
(SSID), and then select a network from the list.
If the network is open (non-encrypted), R4 con-
nects without any further ado; see Completion
below.
Standard encrypted network
To enter the network's key (password),use the
Select control to move the cursor through the
characters and select.
As each character is selected, the key is built up
near the top of the display.
There are three options accessible by turning
Select back before the first characters (0123...) -
Backspace, OK and Cancel.
WPS encrypted network
WPS encrypted networks are identified by '[WPS]'
at the start of the network name, and have three
methods of connection.
Select one and follow the prompts:
• Push Button >
R4 prompts you to press the connect button on
the router. It then scans for a ready Push Button
Connect network and connects.
• Pin > (code number) R4 generates an 8-digit
Code number which you enter into the wireless
router, Access point, or an external registrar
(e.g. advanced versions of Windows Vista).
• Skip WPS >
Enter key as for a standard encrypted network,
above. For more information on setting up a
WPS encrypted network, see your WPS router's
instructions.
UK
43