Meccanica Fadini ELPRO 43 Manuel D'instructions page 16

Elpro 43
GB
EXCLUDING GATE LEAF DELAY ON PROGRAMMING
(when it is required that both gate leafs be opened simultaneously and for single gate applications where one motor only is involved).
Once all the electrical connections to the control unit have been properly made (following the instructions included in the box) with all of the safety
and command accessories as required, programming can be carried out.
NOTE VERY WELL: all of the green LEDs must be ON, otherwise check the connections with any accessory, mainly the NC contacts
!
of the safety devices installed (contacts of the inner and outer photocells, stop contact, safety edges, ...).
PROGRAMMING THE UNIT TO OPERATE ON NO GATE LEAF DELAY MODE
LP
1)
5 seconds
LP
2)
1 pulse
LP LP
3)
LP
4)
Adjust the force and dwell trimmers according to the actual site requirements and type of gate to operate, in full respect of the "the
Force Limitation directive in compliance with EN 12453 and EN 12445 norms".
IMPORTANT: any time force trimmers are readjusted, it is required that programming be made anew.
ELECTRONIC CONTROLLER FOR DARDO 430 GATE OPERATOR
LP
LP
LP LP
ON DOUBLE SWINGING GATES
Press and hold the programming button for 5 seconds (until the LP led
starts ashing): programming mode is thus accessed.
Pulse just once: the LP led light is steady
on, wait.
After 10 seconds the LP led light goes off
and the gate leaves open simultaneously
untill the gate stop is reached in open
limit position.
With the gate in the open limit position the
LP led goes on with steady light: wait about
10 seconds (do NOT press the button). The
LP led goes off and the gate leaves move in
close direction until gate stop is reached.
LP led OFF and asher OFF indicate that
programming is nished.
16