Meccanica Fadini ELPRO 43 Manuel D'instructions page 14

Elpro 43
GB
Accessory
Motor power supply
24 Vdc max 50 mA
relay output or
courtesy light
PC Board
power supply
INSTALLATION ON A SINGLE GATE
Motor power supply
ELECTRONIC CONTROLLER FOR DARDO 430 GATE OPERATOR
Electrical connections
A1 C1 B1 A2 C2 B2
M1 M2
D1 E1 F1 D2 E2 F2
ENCODER ENCODER
M1 M2
st
M1 = Dardo on the 1 gate leaf to open and being also the
pedestrian one, if required
M2 = Dardo on the gate leaf delayed on opening.
Control board power supply
230 V - 50 Hz
N F
A1 C1 B1
M1
D1 E1 F1
ENCODER
M1
M1 = this output is to be used for Dardo on a single mount
ON DOUBLE SWINGING GATES
D2 E2 F2
14
Dip-switches and LED indication
of the various functions
Trimmer Force during travel:
it controls the maximum force that Dardo
applies to the gate during travel and in
F.T.
proportion the resistance on obstacle
contact.
The new setting of force will be performed
on the next open/close/radio command
Trimmer Force during slowdown:
it controls the maximum force that Dardo
applies to the gate during slwdown phase
and in proportion the resistance on obstacle
F.S.
contact.
The new setting of force will be performed
on the next open/close/radio command
Dwell trimmer:
from 1 s to 120 s
Bridge B1 with B2 and carry on
!
programming excluding delay
mode on gate leaves.