System Master Sheet; Changes To The Design / Construction; Changing The Assembly Location - Nussbaum JUMBO LIFT 3500 NT Mode D'emploi

2

System master sheet

2.1 Manufacturer
Nussbaum Automotive Lifts GmbH
Korker Straße 24
D-77694 Kehl-Bodersweier
2.2 Purpose
The JUMBO LIFT 3500 NT - HYMAX 3500 PH lift is a lift for cars up to a total weight of 3,500 kg in normal work shop
operations and a maximum load distribution of 3:2 or 2:3 in the drive-in direction or against the drive-in direction.
Additionally, there is a distinction between cars operated with front or rear drive.
Set up of the standard lift in explosion endangered workshops or humid work shops (e.g. outside and washing halls)
is prohibited. After construction and significant maintenance changes on load carrying parts the lift must be inspected
afterwards by a specialist who approves the changes.
Operation of the lift is done by an operating unit that is located immediately next to the lift.

2.3 Changes to the design / construction

Inspections by a technical expert are required before recommissioning (date, type of change, technical expert signa-
ture).
______________________________________________________________________________________________________
______________________________________________________________________________________________________
Name, address of technical expert
_________________________________________________
Location, date

2.4 Changing the assembly location

Inspections by a technical expert are required before recommissioning (date, type of change, specialist signature).
______________________________________________________________________________________________________
______________________________________________________________________________________________________
Name, address of technical expert
_________________________________________________
Location, date
OPI_JUMBO LIFT 3500 NT_V4.0_DE-EN-FR-ES-IT
_________________________________________________
Technical expert signature
_________________________________________________
Signature of Technical Expert of Safety inspections
65