Safety Regulations; Safety Inspection - Nussbaum JUMBO LIFT 3500 NT Mode D'emploi

4

Safety regulations

When working with systems comply with legal accident pre-
vention regulations according to BGG 945: Comply with
inspection of lifts; BGR 500, operation of lifts; (VBG 14).
Particular attention is drawn to compliance with the fol-
lowing regulations:
• When operating the system, follow safety regulations
and operating instructions in the operating manual.
• The total weight of the accepted load may not exceed
3,500 kg,
• Only personnel aged 18 or over may operate systems
independently, they must be trained in system operation
and have their work verified by the company. They must
be explicitly tasked with operating the system (excerpt
from BGR 500), see transfer protocol.
• During lifting or lowering, the work area of the system
should be clear or people.
• It is prohibited from moving people with the lift.
• It is prohibited to climb onto the system.
• The lift must be completely lowered before the vehicle
is driven on, and it may only be done in the intended
direction.
• For vehicles with low floor clearance or custom equip-
ment, check before driving, whether it could be dam-
aged.
• The set up of standard lifts is not permitted in fire and
explosion endangered work shops.
• Caution when leaving car engines running in enclosed
spaces: danger of poisoning.
• When removing heavy vehicle parts (e.g. motors) the
centre of mass of the vehicle changes. In this case se-
cure the vehicle against falling using suitable means.
• Initial access into the lift may only be done after the
main switch is off and locked.
• Secure the lift against unauthorised use by switching off
the main switch and by using a padlock.
• Always keep the lift and work space clean and dry.

4.1 Safety inspection

The safety inspection is required to guarantee operational
safety of the lift. It is to be done:
1. Before first commissioning after setting up the lift
Use the "single safety inspection" form
2. After first commissioning, check regularly at least once
per year.
Use the "regular safety inspection" form
3. After changes to the lift system construction
Use the "extraordinary safety inspection" form
Single and regular safety inspections must
!
be done by a specialist. It is recommended
to do maintenance at the same time.
i After a change in construction (for example chang-
ing the load carrying capacity or changing the lift-
ing height) and after significant maintenance on load
OPI_JUMBO LIFT 3500 NT_V4.0_DE-EN-FR-ES-IT
carrying parts (e.g. welding work), inspection by a
technical expert is required (extraordinary safety in-
spection).
This inspection book contains forms with a detailed in-
spection plan for safety inspections. Please use the appro-
priate form, record the condition of the inspected system
and leave the completed form in this inspection book.
The labels attached to the lift, such as warn-
!
ings, load capacity stickers, type plate and
other information should not come into con-
tact with aggressive liquids or solvents (thin-
ner, acetone, nitro cellulose thinner, brake
cleaner, brake fluid, etc.), acids, alkalis or
other substances, otherwise there is a risk
that the lettering will disappear and the in-
structions or information will no longer be
legible.
79