Repairs And Replacements; Putting Out Of Use; Dismantling; Emergency Situations - Columbus AKS 70 VDM 62 Mode D'emploi

Balayeuse aspirante et accessories
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

REPLACING THE SIDE BRUSH:
This operation must be performed with the engine off and wearing gloves, using two 10 mm spanners.
Unscrew the three bolts Part. 4 Fig. 18 to detach the side brush Part. 1 Fig. 18 from the plastic flange Part. 5 Fig. 18.
1.
2.
Replace the worn brush and screw up the bolts Part. 4 Fig. 18 to the flange Part. 5 Fig. 18.
Dispose of the used oil through legally prescribed channels Carefully read the attached motor instruction booklet and always:
1 -
Check the level of the oil every 20 work hours.
2 -
First oil change after 50 work hours. The sump contains about 8 hg of oil. The oil recommended for temperature climates is 15W-40.
If the machine is operating outside the temperature zone, determine the right oil by referring to the motor booklet. When changing
oil, use the special oil drain pipe.
3 -
Subsequent oil changes every 200 work hours.
4 -
Clean the motor air cartridge every 25 hours or before if necessary. Replace if necessary (see motor booklet).
_____________________________________________________________________________________________________
THESE REPAIRS AND REPLACEMENTS ARE THOSE THAT HAVEN'T BEEN MENTIONED HERE. THEY MUST BE CARRIED OUT
BY PERSONNEL WITH TECHNICAL SKILLS TRAINED FOR THE PURPOSE. (SEE MANUAL COVER)
_____________________________________________________________________________________________________
   
Remove the batteries from their housing and keep them in a dry and well-ventilated palce. To ensure a long lasting of unused
batteries charge them and eventually top up with distillated water every 30/40 days
   
Clean the dust filters and the bin. if necessary wash the bin as in instructions in "Collection bin" paragraph
_____________________________________________________________________________________________________
DISMANTLING AND DEMOLITION ARE A CUSTOMER'S RESPONSABILITY. THESE OPERATIONS MUST BE PERFORMED IN
ACCORDANCE WITH APPLICABLE REGULATIONS, HANDING THE ENTIRE MACHINE OR ITS COMPONENTS TO COMPANIES
SPECIALISED IN SUCH SERVICES.
_____________________________________________________________________________________________________
In the event of any emergency situations such as, for instance: the machine has accidentally been driven over power cables and these have
wrapped around the central brush or side brush, or an unusual noise is heard coming from inside the machine or engine, hot materials,
inflammable liquids, chemical materials in general, poisons etc. have been picked up ETC:
_____________________________________________________________________________________________
WHEN CHECKING OR REPLACING THE MOTOR OIL, ALWAYS WEAR PROTECTIVES GLOVES, IF POSSIBLE MADE OF
NITRILE WITH COTTON LINING; DO NOT DISCARD THE USED OIL INTO THE ENVIRONMENT AS THIS IS A
POLLUTION HAZARD.
_____________________________________________________________________________________________
CHAP. 14 – REPAIRS AND REPLACEMENTS
CHAP. 15 – PUTTING OUT OF USE
To decommission the motor, read the attached motor manual carefully.
CHAP. 17 – EMERGENCY SITUATIONS
CHAP. 16 – DISMANTELING
24
Vacuum Sweeper
AKS 70|VDM 62

Publicité

Table des Matières
loading

Table des Matières