PRESIDENT JOHNY III USA Manuel D'utilisation page 8

3) DISPLAY
It shows all functions:
The BARGRAPH shows the reception level and the output power level.
4) RF GAIN
Adjustment of the sensitivity during reception. For long distance communications
RF GAIN should be set to maximum. You can reduce the RF GAIN in order to avoid
distortion when your correspondent is close by and when he has no RF POWER.
The normal setting of this function is on maximum (fully clockwise).
5) CHANNEL SELECTOR: Rotary Knob, UP/DN keys on microphone
This knob and keys allow increasing (UP) or decreasing (DN) a channel. A beep
sounds each time the channel changes if the KEY BP function is activated.
See KEY BP function page 10.
6) •F
(short press)
Press this key to enter in mode FUNCTION.
automatically disappears after 10 seconds without pressing any key.
7) WX ~ ALERT ~ •VOX ~ •VOX SET
WX (WEATHER MODE)
(short press)
WX
CB functions are not allowed in
blinks when the function in ON.
mode.
The WX mode allows to hear weather information. When the mode is activated, use
the channel selector knob or UP/DN key on the microphone (5) to move through the
7 weather channels to find the active channel in your local area.
The display shows the selected weather channel and if the unit receives a signal,
icons appears.
Press shortly the WX key in order to activate the
display. A new short press on the WX key disables the
ALERT
(long press)
CB
This function only works in and
Press and hold the ALERT key for 1 second to activate/deactivate the ALERT function.
When the function is ON and a tone is detected at the selected weather channel,
then the unit sounds SIREN tone. "ALERT" and the "WX channel" blinks on the display.
The unit cancel CB or PA mode and go to
During a SIREN tone sound, press any key to stop the sound, "ALERT" and the "WX
channel" stops blinking on the display.
Note: The SIREN tone sounds when ALERT is detected in the selected WEATHER channel
only. Use first SCAN function in
in all the WEATHER channels.
•VOX
(•F + short press)
The VOX function allows transmitting by speaking into the original microphone (or
in the optional vox microphone) without pressing the PTT switch (13). The use of an
optional vox microphone connected to the rear panel of the transceiver (E) disables
the original microphone.
Press one time the •F key and short press the •VOX key in order to activate the VOX
function. "VOX" appears on the display. Repeat the key combination to disable the
function. "VOX" disappears.
8
WX mode. "WX" appears on the
WX mode "WX" disappears.
PA WX
mode. It does nor work in mode.
WX mode.
WX mode (see § SCAN page 10) for detect tones