PRESIDENT JOHNY III USA Manuel D'utilisation page 10

WX MODE
Press and hold the SCAN key for 1 second to activate the SCAN function (all the
WEATHER channels) in an increasing way. "SCAN" is displayed. The scanning stops
as soon as there is a busy channel. The scanning automatically starts 3 seconds after
the end of the transmission and no key is activated during 3 s. The scanning starts
again in an increasing way by turning the rotary knob to the right, or in a decreasing
way by turning the rotary knob to the left.
Note: If the ALERT function is activated, the SIREN tone sounds (see § ALERT page
8) when a tone is detected in the selected WEATHER channel only. Use first SCAN
function in WX mode for detect tones in all the WEATHER channels.
A new long press on SCAN disables the SCAN function.
•KEY BP
(•F + short press)
Beep on changing the channel, keys etc...
Activate the KEY BP function by pressing 1 time the •F key and short press the •KEY
BP key. A beep sounds. "BP" is displayed. Press again 1 time the •F key and short
press the •KEY BP key to deactivate the function. "BP" disappears.
10) MEM ~ STORE
Allows to memorize an channel with following parameters: NB (ON/OFF)HI-CUT (ON/
OFF).
MEM
(short press)
To recall a memory:
- Short press MEM key, "MEM" appears on the display. If the KEY BP function is activated
a beep sounds. The memorized channel is activated. Short press again MEM to go
back to previous operating channel.
STORE
(long press)
To memorize: Select the channel to be memorized.
- Press the MEM key for 1 second; "MEM" appears in the display. If the KEY BP function
is activated a long beep confirms the saving.
Only one channel can be memorized. Store a second channel will delete the previous
from memory.
To delete a memory:
- Switch off the transceiver.
- Keep the MEM key pressed and switch on the transceiver.
- The memory is deleted.
11) CB/PA ~ LOCK ~ •Colour
CB/PA
(short press)
Short press the CB/PA key to alternate between
PA MODE
An external loud speaker can be connected to the unit by the PA jack plug situated
on the back panel PA.SP. (D). The
displayed.
ROGER, SCAN, MEM, VOX are not allowed in
while SCAN function, instant channel 9/19 mode or
The CB message received will be directed towards the PA speaker and be amplified.
The message transmitted into the microphone will be directed towards the PA speaker
and be amplified. "PAon" is displayed, Meter numbers indicate signal level.
LOCK
(long press)
Allows to lock all the keys on the front panel and the rotary knob. An error beep
sounds when a key is used and the LOCK function is activated. A long press on
LOCK activates/deactivates the LOCK function.
the function is activated.
Transmission (microphone or vox) and reception remain active.
10
CB PA
and mode.
PA volume is regulated by VOL knob (1). "PA" is
PA mode. If the user set ON
WX
mode, these are canceled.
appears on the display when
PA
mode