AVS Electronics XSAT2 Mode D'emploi page 12

CONNECTION WITH THE CONTROL UNIT
E
Notes:
N
• The satellite boards can be connected in parallel
G
on the same RS485 serial port.
• The connected satellite boards can be different
models (XSAT2, XSAT8, SAT03, SAT04 and Sat
W), as long as they have different addressing
(see "Satellite addressing).
• We recommend shielded cables with four wires
of 0.5 mm² each.
• Total connection cable length can reach 600 m;
it must be divided between all devices connected
to the same RS485 serial port (satellite-boards,
keyboards, etc.)
ATTENTION: If the satellite is powered with the supplemental power supply, refer to the
diagram contained in the POWER1Q / POWER4Q manual for connection.
Satellite addressing
Bear in mind that there cannot be more key satellites with the same address, otherwise they will stop
working and the control panel will activate a tamper alarm.
If the installation includes multiple satellite-boards, even different models, one must address them by
positioning the dip according to the table below:
DIP SWITCH
1 2 3
OFF OFF OFF OFF
ON OFF OFF OFF
OFF OFF
OFF ON
ON ON OFF OFF
OFF OFF ON
ON OFF ON
OFF ON ON
ON ON ON
OFF OFF OFF
ON OFF OFF
OFF ON OFF
ON ON OFF
OFF OFF ON
ON OFF ON
OFF ON ON
ON ON ON
If XSAT2 is set as double (DIP 5 in ON) for handling 16 O.C. outputs, besides the
assigned address "N", it will also occupy the address "N + 1" on the control unit.
Ex: if XSAT02 is set on double satellite with address 1, there cannot be any other satellite
with address 2.
4 XTREAM
SATELLITE 1
SATELLITE 2
SATELLITE 3
SATELLITE 4
OFF SATELLITE 5
OFF SATELLITE 6
OFF SATELLITE 7
OFF SATELLITE 8
ON SATELLITE 9
ON SATELLITE 10
ON SATELLITE 11
ON SATELLITE 12
ON SATELLITE 13
ON SATELLITE 14
ON SATELLITE 15
ON SATELLITE 16
Control unit
CONTROL UNIT MODEL
Logitel 8 Plus ADVANCE
and ADVANCE 88
SATELLITE 1
SATELLITE 2
SATELLITE 3
SATELLITE 4
-
-
-
-
-
-
-
-
-
-
-
-
- 12 -
Satellite board
Keypad
Concorde Plus 54
SATELLITE 1
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-