AVS Electronics XSAT2 Mode D'emploi page 10

TECHNICAL FEATURES
E
Satellite boards XSAT2 and XSAT8 for single and double balancing lines, which can be connected to
N
the serial port of the control unit with four wires. They are completely programmable from the
G
keyboard of the actual control unit or the remote workstation using a computer equipped with a
dedicated program.
The boards can be housed inside the control unit housing or in the CONT SAT W and CONT SX
housings.
Input zones
Open Collector
Outputs
Programming
Connections:
Electronic board sizes:
Housings:
Environmental
conditions:
Voltage:
Accessories
Absorption
The power supply must come from very low safety voltage circuit with the characteristics of a
limited power source protected by a fuse.
AVS ELECTRONICS S.p.a. reserves the right to make amendments at any moment and
without notice.
INSTALLATION
PERSONNEL
• XSAT2: n° 2 (+ 2 only Xtream control unit)
• XSAT8: n° 10 (+ 10 only Xtream control unit)
• they can be configured with automatic detection of alarm status
and tamper proof by way of double balancing, individually
programmable; the areas can be programmed individually in one of
the possible operational modes that the control unit can manage.
• XSAT2: n° 8 + 8 transistorised outputs (50mA – Open Coll ector) of
which 8 on pin connector for connection with the board with
optional relay and no. 8 in terminal board.
• XSAT8: no. 8 transistorised outputs (50 mA- Open Collector) on
pin connector for connection with optional relay board
• They can be associated with any function of the control unit and
are completely configurable (impulse or time activation).
• From the keyboard with guided menus on the backlit display.
• From computer, using the dedicated program.
• With four wires.
• (L x H x D) 81 x 53 x 24 mm.
• Individual housing CONT SX
• Multiple housing CONT SAT W
• +5 ° C / +40 ° C
• power supply nominal voltage: 10.5 V— - 15 V—
• XMR2: 2 relay interface board
• MR4: 4 relay interface board
• MR8: 8 relay interface board
• XSAT2: 32 mA
• XSAT8: 40 mA
AND MAINTENANCE
- 10 -
MUST BE EXECUTED BY QUALIFIED