Terminal Board - AVS Electronics XSAT2 Mode D'emploi

Satellite board
8 7 6 5 4 3 2
DA DB
+ FROM DB -
+ -
L1, L2
L3................L10
OC16............OC9
DIP 1,2,3,4
DIP 5
O.C.
S1
S2
Tamper Button
On the satellite board there is a tamper proof button that can be excluded by
closing bridge S2.
If the Tamper button present on the board is not used, satellite protection
occurs by using an input area programmed in TAMPER mode.
1
O.C.
S1
L1

TERMINAL BOARD

• RS485 serial, to be connected to the control unit serial port
• Power supply output
• Area inputs
• XSAT2: N° 8 transistorised Open Collector outputs of the satellite.
• XSAT8: area inputs.
N.B. Areas L9 and L10 can be used as area input only if the satellite is
combined with the XTREAM control unit
• For addressing the satellite. See related table
• XSAT8
Unused
• XSAT2
For configuration as Single or Double Satellite
CONNECTORS
• N° 8 transistorised Open Collector outputs of the satellite
• Unused
• Closed: satellite tamper excluded
• Open: satellite tamper active
L2 L3 L4 L5
OC16 OC15 OC14 OC13 OC12
DIP SWITCH
- 11 -
S2
TAMPER
L6 L7 L8 L9 L10
OC11 OC10 OC9
S2
E
N
G
TAMPER