Commissioning; Install Hard Disc In The Digital Recorder - Renkforce 808574 Notice D'emploi

8. Commissioning

a) Install Hard Disc in the Digital Recorder
For the digital recorder to be able to record the signals of the connected cameras, you need to install a
suitable SATA hard sic of size 8.89 cm (3.5") with a capacity of max. 1 TB. A hard disc is not enclosed. It
must be ordered separately.
The digital recorder must be replaced to install the housing lid. You will require a suitable Phillips
screwdriver for this.
If the digital recorder is operated permanently (24h per day, 7 days per week), observe that a hard
disc must be used that is suitable for permanent operation.
Proceed as follows:
• First disconnect the digital recorder from all connected cables.
• Put the digital recorder on a clean, level, flat table. Use a suitable soft underground so that neither the
digital recorder nor the table will take damage.
• To remove the housing lid, turn out 9 screws in total.
First start with the 2 screws at the left and right, then unscrew the 5 screws at the rear. Lift off the housing
lid upwards carefully then.
23