Dell M8428-k Guide De Démarrage page 7

FIGURE 3
Description of the M8428-k external ports, status LED's and release latch.
Modify the converged network switch Ethernet management IP address
By default, the Ethernet management IP address for the converged network switch is configured as 10.77.77.77 with
a default Ethernet subnet mask of 255.255.255.0. The default gateway is 0.0.0.0.
Reset the IP address using one of the available methods, which store the IP address values on the switch module:
•
Blade server enclosure CMC graphical user interface (GUI).
•
Blade server enclosure CMC CLI.
•
Dell M8428-k command line interface (CLI).
After modifying the switch module's IP address and domain name (if the switch module is in full fabric mode), we
recommend that you cable all external ports to fabric connections before bringing the switch module online.
NOTE
It is recommended that you set the IP address using the blade server enclosure CMC GUI application because this
enables centralized management of the converged network switch.
Using the CMC GUI to set the IP address
Browse to the Chassis Management Controller (CMSC) IP address and login.
To change the IP address, use the following steps:
Dell M8428-k Getting Started Guide
MHWKY A01
7 of 192