Setting The Temperature; Cleaning & Maintenance - Inventum HNK115 Mode D'emploi

Masquer les pouces Voir aussi pour HNK115:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

4.4 Setting the temperature

To increase the temperature, press the
Setting 1:
minimum heat
Setting 2-5: individual heat setting
Setting 6:
maximum heat
NOTE
The fastest way to warm up the heating pad is to initially set the highest temperature setting of the controller, first.
NOTE
This heating pad has a turbo function, which allows the heating pad to warm up faster in the first 10 minutes.
CAUTION
If the heating pad is being used over several hours it is
recommended to use the lowest setting (1) of the control to avoid
overheating the heated body part, which may lead to burns to the
skin.
4.5 Automatic switch-off
This heating pad is equipped with an automatic switch-off function. This turns off the heat supply approx. 90 minutes
after the initial use of the heating pad. A part of the displayed temperature settings on the controller then begins to
flash. So that the heating pad can be switched back on, the side sliding switch (3) must first be set to setting "0" (OFF).
After about 5 seconds it is possible to switch it on again.
4.6 Switching off
To switch the heating pad off, set the sliding switch for ON/OFF to setting 0 (OFF) position. The temperature settings are then no
longer illuminated.
NOTE
If the heating pad is not in use, switch the side sliding switch for ON/OFF to the OFF (0) position and remove the mains plug
from the socket. Then disconnect the controller from the heating pad by unplugging the plug-in coupling.
5
cleaning & maintenance
WARNING
Before cleaning, always remove the mains plug from the socket first. Then disconnect the controller from the heating pad by
unplugging the plug-in coupling. Otherwise there is a risk of electric shock.
CAUTION
• The controller must never come into contact with water or other liquids. Otherwise, the controller may be damaged.
To clean the controller, use a dry, lint-free cloth. Do not use any chemical or abrasive cleaning agents.
The textile cover can be cleaned in accordance with the symbols on the label and must be removed from the heating pad prior to
cleaning. Small marks on the heating pad can be removed with a damp cloth or sponge, or if necessary, with a little liquid detergent for
delicate laundry.
CAUTION
• Please note the heating pad must not be dry-cleaned, wrung out, machine dried, pressed or ironed.
In case of heavier soiling, this heating pad can be washed in a washing machine. Set the washing machine to a particularly gentle, 30°C
cycle (woolens programme). Use a wool laundry detergent and follow the manufacturer's instructions.
14
English
button. To reduce the temperature, press the
button.

Publicité

Table des Matières
loading

Table des Matières