Peavey Classic 30 Delta Blues Mode D'emploi page 23

®
Delta Blues Control Panel
13
15 14 12
POWER SWITCH
1
Switch to "ON" position to turn on.
STANDBY SWITCH
2
This two-way switch allows the amp to be placed in the STANDBY mode. In the STANDBY position the
tubes stay hot but the amplifier is not operational. Switching to the ON position places the amp in active
mode.
PILOT LIGHT
3
Illuminates when AC power is being supplied to the unit.
TREMOLO SPEED
4
The speed control determines the rate at which the signal is modulated. This control varies the speed
of the Tremolo master oscillator and should provide any speed desired for modern music. Clockwise
rotation of the speed control increases the speed of the modulation of the tremolo. The Tremolo feature
is defeatable from a remote footswitch.
TREMOLO INTENSITY
5
The intensity control is used to vary the amount of amplitude modulation of the clean signal. It can be
adjusted from barely perceptible to dramatic modulation. Clockwise rotation of the intensity control
increases the depth of the tremolo.
EFFECTS RETURN
6
Input for returning signals to external effects or signal processing equipment.
EFFECTS SEND
7
Output for supplying signal to external effects or signal processing equipment.
TREBLE, MIDDLE AND BASS EQ
8
Passive tone controls that regulate high, mid, and low frequencies, respectively.
BOOST SWITCH
9
Boosts the overall system gain. Depress to the "in" position to activate.
REVERB
10
Reverberation is an echo effect. Rotate clockwise to increase the effect.
POST GAIN
11
Controls the overall volume level of the Lead channel. The final level adjustment should be made after
the desired sound has been activated.
PRE GAIN
12
Controls the input volume level of the Lead channel.
CHANNEL SELECT SWITCH
13
Allows selection of the Lead or Normal channel.
Note: Channel selection may also be achived by the remote footswitch. If remote selection is desired,
the channel switch must be in the "in" (Lead) position.
NORMAL GAIN
14
Controls the volume level of the Normal channel.
INPUT
15
The input jack will accept signals from all types of guitar pickups. Be sure to use a high-quality shielded
cable to connect the guitar to the amplifier.
11 10
9
6 7
8
5 4 3 2 1