Peavey Classic 30 Delta Blues Mode D'emploi page 22

®
Classic 30 Rear Panel
18 17
REMOTE CHANNEL/BOOST SWITCH JACK
14
This is provided for the connection of the optional remote footswitch. The footswitch is used to select
the Lead or Normal channels and activate the boost. When using the remote footswitch, always insert
the plug fully (second click) to ensure proper operation. (requires Peavey footswitch 03054360)
REVERB SWITCH JACK
15
This is provided for the connection of the optional remote footswitch. The footswitch is used to defeat
reverb. (requires Peavey footswitch 03051000)
EXTERNAL SPEAKER JACK
16
This is provided for connection of an external speaker cabinet. Minimum total impedance is 8 ohms.
Caution: The on/off switch in this unit does not break both sides of the primary mains. Hazardous
energy can be present inside the chassis even when the on/off switch is in the OFF position.
FUSE
17
The fuse is located within the cap of the fuseholder. If the fuse should fail, IT MUST BE REPLACED
WITH THE SAME TYPE AND VALUE IN ORDER TO AVOID DAMAGE TO THE EQUIPMENT AND TO PREVENT
VOIDING THE WARRANTY. If the amp repeatedly blows fuses, it should be taken to a qualified service
center for repair.
WARNING: THE FUSE SHOULD ONLY BE REPLACED WHEN THE POWER CORD HAS BEEN
DISCONNECTED FROM ITS POWER SOURCE.
AC POWER INLET:
18
This is the receptacle for an IEC line cord, which provides AC power to the unit. Connect the line cord to
this connector to provide power to the unit. Damage to the equipment may result if improper line voltage
is used. (See line voltage marking on unit).
Never break off the ground pin on any equipment. It is provided for your safety. If the outlet used does
not have a ground pin, a suitable grounding adapter should be used, and the third wire should be
grounded properly. To prevent the risk of shock or fire hazard, always make sure that the amplifier and
all associated equipment is properly grounded.
NOTE: FOR UK ONLY
As the colors of the wires in the mains lead of this apparatus may not correspond with the colored
markings identifying the terminals in your plug, proceed as follows: (1) The wire that is colored green
and yellow must be connected to the terminal that is marked by the letter E, or by the Earth symbol, or
colored green or green and yellow. (2) The wire that is colored blue must be connected to the terminal
that is marked with the letter N, or the color black. (3) The wire that is colored brown must be connected
to the terminal that is marked with the letter L, or the color red.
16 15 14