ShelterLogic ShelterCoat 12'W x 8'H Peak Instructions De Montage page 6

12'x20'x8' is the BASE frame dimension. Your model may have more middle ribs than shown in the illustration on
page 3. You will receive one extra rib for every extra 4 ft. of building length that you purchase. The basic frame
assembly will remain the same. The cover will be the correct size for the length of the building you purchased.
1. PLOTTING THE FRAME:
Before building your shelter, you should choose a flat area on
your property and plot your shelter.
A. Stake out the area for the shelter in the desired spot. The width of
the area should be at least equal to the width of the shelter and the
length should be equal to the length of the shelter Fig. 1.
B. Measure diagonally from corner to corner (A & B). These
measurements should be the same. If they are not equal the stakes
need to be adjusted until the width, length and inside measurements
are correct.
2. ASSEMBLE END RIBS
Assemble end ribs as shown in Fig. 2. Securely
fasten all of the joints with the hardware indicated.
3. ASSEMBLE MIDDLE RIBS
Assemble middle ribs as shown in Fig. 3. Securely
fasten all of the joints with the hardware indicated.
NOTE: FRAME EXTENSION KIT
Fig.2
10132
10127
10128
Fig.3
10132
10126
10113
Page 6
13 ft.
WIDTH
A
B
10121
10125
Use #10114
/
1
" x 2" L
4
Bolts
10131
10125
Use #10114
/
1
" x 2" L
4
Bolts
05_GP-AA-XXXXXXA-012XXX08_F0
Fig.1
BUILDING
LENGTH
10125
10132
10127
10128
10125
10132
10126
10113