ShelterLogic ShelterCoat 12'W x 8'H Peak Instructions De Montage page 11

11. INSTALLING COVER AND COVER RAILS
A. Make sure cover is centered on frame. There should be an equal amount of overhang at all four corners.
B. Insert the "S"- Hook on ratchet into hole on the leg bend. Insert the webbing into the spindle of the ratchet
and pull tight. Wind the ratchet so that the webbing overlaps itself.
C. Slide cover rails (#10110) through fabric pockets at each leg and reattach with clamps to each leg. Repeat
this on other side. Push down on cover rails to tighten cover, before tightening bolts completely.
D. Check and tighten Ratchets and Cover Rails monthly to ensure the cover is tight.
NOTE: The ShelterLogic
be oriented as shown below.
INCORRECT
REAR
Webbing and Ratchets Securing Cover
logo should
®
End Rib Cover Rail Clamps
CORRECT
10112
10115
10110
01010
Page 11
COVER RAILS
10110
Middle Rib Cover Rail Clamps
10110
01010
01010
05_GP-AA-XXXXXXA-012XXX08_F0
Fig. 12
FRONT
10111
10115
10110