FloTech FT555F Mode D'emploi page 33

FloTech FT555F Automatic Overfill System Tester
Step 4) Press the "GO" button to start the test. When the test is
complete the screen will display the PASS / FAIL status and a
wet/dry status for each of the compartments enabled during the
setup. A square under the number indicates a dry sensor or a dash
under the number indicates a wet or missing sensor. If connected
to an Onboard Monitor dashed lines will show and no black bars.
Step 5) Press the "TEST SELECT" button to move on to a new
test, press "GO" to restart the test, or press the "ON/OFF" button
to turn the tester off.
Optic pass when connected to sensors is shown above. A black
square will light for each good sensor.
Optic pass when connected to an onboard monitor will show
dashes for sensor status. Onboard monitors do not have a
diagnostic connection to the rack monitor and do not pass the
number of good sensors through the onboard monitor to the socket.
FT555F Truck Tester 10784PA REV C Page
13