Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
FloTech FT555F Automatic Overfill System Tester
Welcome Screen
After completing the Initial System Setup the welcome screen will
be displayed. This screen will be displayed every time the FT555F
Automatic Tester is turned on.
The Welcome Screen shows the version software the FT555F is
running and the battery health status in bars. 5 bars represent full
battery capacity. If 2 or less bars are displayed, a warning beep will
sound and a warning message will flash for a few seconds.
Batteries should be changed at your next convenience.
Power ON/OFF
Press the ON/OFF button once to turn the tester on. Push the
button again to turn the tester off. The tester has a display back
light for dark conditions. After turning on the tester, press and
hold the ON/OFF button for 2 seconds and the back light will turn
on. Press and hold again for 2 seconds and the back light will go
off.
FT555F Truck Tester
10784PA REV C
Page 7
Publicité
Table des Matières
