4. PERPENDICULARITY: The line
should be aligned vertically with
the cut from the top of the board
to the bottom, as shown.
With the miter saw head in the
UP position, place board verti-
cally against fence. Adjust the top
screw (E) to align laser to the cut.
5. PARALLELISM: The
E
5
laser
should be aligned with the cut
from front of board to the fence.
With the miter saw head in the
UP position, lay board flat on
table and against fence. Adjust
front screw (F) to align laser to
the cut. Rotate the miter saw
guard if necessary.
F