Warning Labels - DeWalt DW7187 Guide D'utilisation

WARNING LABELS

For your convenience and safety, the following label is on your
laser (Fig. 1).
CAUTION: LASER
RADIATION – DO
NOT STARE INTO
BEAM. CLASS 2
LASER PRODUCT.
CAUTION: CLASS 2
LASER RADIATION
WHEN OPEN DO
NOT STARE INTO
THE BEAM.
Laser
Information
The DW7187 Miter Saw
Laser System is a Class 2
laser product and complies
with 21CFR 1040.10 and
1040.11 except for devia-
tions pursuant to laser notice No. 50, dated July 26, 2001.
Installation of Miter Saw Laser
System
WARNING: Read all instructions for the Installation of Laser
Power Supply and the Installation of Laser before proceeding
with the Installation of the Miter Saw Laser System.
INSTALLATION OF LASER POWER SUPPLY (LPS)
WARNING: Disconnect the saw from the power source.
1. Remove the two screws from the miter saw handle with sup-
plied T20 Torx wrench. Save the screws for the assembly of
the Laser Power Supply (LPS) in Step 4. Retain the handle
cover for future use if LPS is removed.
FIG. 1
2. Attach the connections to the LPS.
3. Arrange the wire connection
such that the wide portion of the
connector is placed against the
bottom of the miter saw handle
and fit the LPS to the handle.
2