Initial Use; Charging The Device; Attaching The Brush; Use - Beurer FC 95 Mode D'emploi

7.

Initial use

7.1 Charging the device

Charge the device for at least 6 hours before initial operation. To do this, proceed as follows:
1. Insert the mains cable into the charger.
2. Insert the mains adapter into the socket.
3. Insert the facial brush into the charger from above. While charging is in progress, the LED lights for the ON/OFF/speed
button light up alternately in a circle. Once the facial brush has been fully charged, the LED lights for the ON/OFF/
speed button light up permanently.

7.2 Attaching the brush

The device features four different brush attachments.
• Brush attachment for normal skin
• Brush attachment for sensitive skin
• Brush attachment for deep­pore cleansing
• Exfoliating brush attachment to gently remove excess skin cells
1. The attachment you wish to use should be fixed from above onto the mounting fixture of the device.
2. To remove the brush attachment after use, pull it up and off.
8.

Use

1. Moisten the attached brush attachment with water. Never use the device with a dry brush attachment as this can ir­
ritate the skin.
2. Apply the cleansing gel to your facial skin.
3. To switch on the device, press and hold the ON/OFF/speed button for 1 second. The brush attachment will begin to
rotate.
4. The device features a slow, medium and fast speed setting. To switch between the individual speed settings, briefly
press the ON/OFF/speed button. The selected speed setting is displayed via the corresponding LEDs that are lit up.
5. Using the rotation button, select your desired rotation level. The device has circular rotation for gentle facial cleansing
and oscillating rotation for thorough facial cleansing.
6. Now apply the device gently to your face and cleanse your facial skin using even movements to remove residue, dirt
and dead skin cells.
Note
To ensure comfortable treatment, do not apply the rotating brush attachment too firmly to the skin. Treat each section of
skin for a maximum of 20 seconds only.
The brush features a 1­minute timer and stops every 20 seconds for 1 second to indicate that you should switch to clean­
sing a different area. The facial brush switches itself off automatically after 3x 20 seconds. The recommended application
period per use is 1 minute.
7. Switch off the device after use. To switch off the device, press and hold the ON/OFF/speed button for 1 second.
8. Cleanse your face thoroughly with water to remove any residue from your skin.
9. Pat your skin dry with a towel and then apply a moisturising cream using even, circular movements.
9.

Cleaning

9.1 Cleaning the brush attachments

IMPORTANT
Before beginning cleaning, pull the brush attachment up and off.
• Clean the brush attachment thoroughly with water after each use.
12