Bradley S19-921 Guide D'installation page 5

Installation
Pedestal
Step 3: Test eyewash unit
1 . After completing installation, test the eyewash station for proper
operation by pulling down the tray . Check for proper water
flow and quickly close the tray . Visually inspect the eyewash
unit weekly for cleanliness and proper solution level (per ANSI
Standard Z358 .1-2009) . When the water level drops below the
15-minute fill line, the tank must be emptied and then refilled . To
refill the eyewash tank, follow the procedures outlined in Step 2
found on page 4 .
2 . Attach the eyewash inspection tag (supplied) to the eyewash unit .
This tag is to be used for weekly inspection documentation . Hook-
and-loop fasteners are provided to attach the tag to the unit .
3 . If the eyewash unit is not working properly, remove it from the
hazard area and contact Bradley Corporation immediately .
Bradley • 215-1546 Rev. P; ECN 16-05-066
Tank
Cap
Snorkel
Clamp
Latch
Pierce
Drain Hole
11/21/2016
S19-921
5