Key-Lock Function; Intelligent Charging Function; Single Side Band (Ssb) - Tecsun PL-660 Manuel D'utilisation

To activate the key lock function, press & hold the [
appears on display. Press & hold it again with "
key lock function.
With radio off, install 4 x UM3 (AA) rechargeable batteries to activate the built-in
charging function.
Use the external adaptor to connect the radio for charging. The symbol " " will
advance from the bottom to top during power charging. It stops when batteries are
fully charged.
For Alkaline batteries, please switch off the rechargeable function. (Press the
[BATTERY] button until the " " is disappear at the top left corner of LCD when
the radio is at off mode)
Notes:
1. Insist to use up all power of rechargeable batteries before charging again. This
could extend the usage time of battery and keep them in good conditions.
2. 4 pcs of batteries to be used as a group and don't separate them for other usage
and mix using those batteries with different power capacity.
3. Please don't charge on any non-rechargeable battery in the radio, this will cause a
hazard or damage to your radio.
4. Please do not use any other external adapter with different voltage.
1. In Shortwave mode, press the [SSB] button repeatedly to select Upper Side Band
(USB) or Lower Side Band (LSB).
"USB" showing on the display indicates USB selection.
·
· "LSB" showing on the display indicates LSB selection.
· "USB" and "LSB" disappearing means switching to SW.
2. Suggest to key in the SSB frequency directly
3. Then fine tune the [SSB BFO] knob to achieve better sound fidelity.

KEY-LOCK FUNCTION

INTELLIGENT CHARGING FUNCTION

SINGLE SIDE BAND (SSB)

www.tecsunradios.com.au
] button with "
" disappears to deactivate the
"
-- 23 --
.