Alarm Setting (By Radio Only); Setting The Alarm Station; Setting The Alarm Time - Tecsun PL-660 Manuel D'utilisation

SETTING THE ALARM STATION:

1. Turn on the radio, then tune into your favorite station for alarm by radio and
adjust your desired alarm volume level.
2. Press the [MEMORY] button and then immediately press the [TIMER A] or
[TIMER B] button and notice "
the preset alarm station.

SETTING THE ALARM TIME

1. Press & hold the [TIMER A] button
with hour flashing in the upper right
corner of display, then rotate the
[TUNING] knob to adjust the hour.
2. Press the [TIMER A] button with
minutes flashing, and then rotate the
[TUNING] knob to adjust the minute.
3. Press the [TIMER A] button again,
then rotate the [TUNING] knob to
select from 1 ~ 90 minutes to set the
Alarm Off Timer.
4. Press the [TIMER A] button to
confirm the setting.
If the [TIMER A] button has not been pressed again within 3 seconds, the unit
will automatically confirm the alarm setting.
Note: The unit will turn on automatically and switch to the preset alarm station and
time. It will also be turned off automatically when it reaches the preset time.

ALARM SETTING (By Radio only)

www.tecsunradios.com.au
" or " " flashing on the display to confirm
-- 19 --
.