M-system MFTD-106 Série Mode D'emploi page 230

OVEN DOORS - CLEANING THE
PANES OF GLASS
The oven door has two panes. To clean
these, you need to remove the inner pane.
REMOVING THE INNER PANE OF GLASS
• Open the door to the full extent (fig.
7.9a).
• Attach the retaining rings to the hooks
on the left and right hinges (fig. 7.9b).
• Gently pull out the inner pane of glass
(Fig. 7.10a)
• Clean the glass with an appropriate
cleaner.
• Dry thoroughly, and place on a soft
surface.
• Now you can also clean the inside of
the outer glass.
Do not use harsh abrasive cleaners
or sharp metal scrapers to clean the
panes of glass since they can scratch
the surface, which may result in shat-
tering of the glass.
REPLACING THE INNER PANE OF GLASS
• Check that the four rubber pads are in
place (D in Fig. 7.10b).
• Check that you are holding the pane
the correct way. You should be able
to read the wording on it as it faces
you.
• Insert the inner pane in the left E and
right F side guides (fig. 7.10c) and
gently let it slide up to the retainers H
(fig. 7.10d).
• Unlock the oven door by opening it
completely and closing the lever on
the left and right hinges (fig. 7.9a).
It is normal the opened gap between the
top edge of the inner glass and the top
of the door. This allows the cooling air
circulation.
230
Fig. 7.10a
D
Fig. 7.10b
E
Fig. 7.10c
Fig. 7.10d
F
H