Disposal Of Unit; Operation - Omcan BC-IT-0103-T Manuel D'instructions

Installation
Lift the appliance to separate it from the pallet. Remove the packing (B) and the protective film avoid using
abrasive brushes or other damaging materials for the appliance's surfaces (C). Check that the appliance is
perfectly levelled. Regulate the adjustable feet if necessary. Place the appliance away from heat sources and
in a ventilated room.
When using the appliance, never obstruct the air inlet when the appliance in on, so as not to compromise its
performance and safety.
Placing the appliance in a site easy to join, so every type of maintenance, control and repair may be
done easily.
UNPACKING AND DISPOSAL
Place the appliance on the ground in its chosen position. Check that the serial number corresponds to the
transport documents. Check for visible damages. Keep the packing out of the reach of children, as it could be
a danger hazard. Discharge the packing products to the specialised collection or recycling points in respect of
the existing regulations.

DISPOSAL OF UNIT

Before scrapping the appliance, keep it inoperative by removing the power cable, eliminating all parts of the
appliance that could constitute an hazard and invalidate locks, hinges and any other closing devices to avoid
that children playing could be trapped inside or injured.
IMPORTANT: COMPLY WITH LOCAL REGULATIONS IN FORCE CONCERNING THE FINAL DISPOSAL
OF THIS TYPE OF EQUIPMENT.

Operation

START-UP
Before connecting the appliance check that the data on the serial plate correspond to
the actual electrical supply.
The serial plate giving the electrical data required in the installation is placed in the
right side.
The installation must be made according to the instructions given in this section, by
professionally qualified personnel.
THE ELECTRICAL SAFETY OF THIS APPLIANCE IS GUARANTEED ONLY WHEN
IT IS CONNECTED TO AN EFFICIENT EARTHING PLANT AS PRESCRIBED BY
9