Height Adjustment; Securing Child - Jole i-Gemm 3 Manuel D'instructions

Height Adjustment

for Head Support and Shoulder Harnesses
see images -
17 20
Check that Shoulder Harness Straps are set at the proper height.
Please choose the proper pair of shoulder harness slots according to
the child's height.
!
The bottom of headrest must be level with the highest point of
child's shoulder, it is shown as
18
!
If the Shoulder Harness Straps are not at proper height, the child
might be ejected from the enhanced infant child restraint if there is a
crash.
Squeeze the head support adjustment lever
push down the head support until it snaps into one of the 7 positions.
The head support positions are shown as
11
, but not above the shoulder line.
17
, meanwhile pull up or
19
20

Securing Child

in the enhanced Infant Child Restraint
see images -
21 26
Note
1. Infant insert is for children's protection. Children whose height
is under 60cm are suitable to use the infant insert.
2. Before using the insert, please add the foam wedge.
3. After the child is placed in the seat, check if the shoulder
harnesses are set to the correct height.
Remove the body portion of the infant insert
when the infant's shoulders no longer fit
comfortably.
1. While pressing the harness adjustment button, pull completely the
two shoulder harnesses of the enhanced infant child restraint.
2. Unlock the buckle of the harnesses by pressing the red button.
3. Place child into the infant carrier module and lock the buckle.
4. Tighten the shoulder harnesses by pulling adjustment webbing.
Detaching Canopy and Seat Pad
see images -
27 32
To re-assemble the soft goods, reverse the aforementioned steps.
21
22
23
&
24 25
26
12