TRACE ELLIOT Elf Combo Manuel Du Propriétaire page 6

(13) DI GROUND LIFT switch
Pressing this switch in will disconnect the ground connection from pin 1 on the DI output XLR socket(s).
Usually this should be left in the out position however there may be certain situations when connecting from
the DI socket(s) to another device that a hum is produced due to a ground loop. If this happens then pressing
the GND LIFT switch in should eliminate the problem.
(14) DI OUT XLR
This is a low impedance balanced output for connecting direct to a stage box or mixer for live or studio use. It
gives the engineer a strong, clean signal without any overspill from other instruments. The XLR socket is wired
as normal: pin 1 = Ground, pin 2 = Signal +, pin 3 = Signal –
Note: This DI OUT XLR is configured "Post EQ".
6