Trust PREMIUM Serie Mode D'emploi page 5

3. DOWNLOAD APP
To connect the sensor with a Z1
ZigBee bridge or ICS-2000/Smart
Bridge, first get the App by scanning
the QR code or go to trust.com/
zigbee and install it.
4. CONNECT SENSOR
A In the App, select a room,press the
+ button and follow instructions.
For manual set up of push-
notifications go to the rules tab,
press the + button and select
notification wizard.
5. MOUNT THE SENSOR
A Mount the arm of the sensor on a
flat surface and secure it with the
included screws.
B Place the sensor on the
1
mounting arm.
Secure the sensor by pulling it
2
down on the mounting arm.
ZPIR-8000 MOTION SENSOR EN
RESET SENSOR AND
ACTIVATE CONNECT MODE
Warning: This step will remove
the sensor from the Z1 ZigBee Bridge
or the ICS-2000/Smart Bridge. To
reset the sensor press the button in
the hole at the side of the sensor for
approximately 5 sec with the included
pin. The LED will flash fast to confirm
the reset.
Activate connect mode: After
resetting the sensor you can activate
the connect mode by pressing the
button for approx. 1 sec. The LED
will flash for 1 minute to indicate the
connection mode.
The wireless range increases when
you add more ZigBee products
(meshing). To learn more about
meshing go to trust.com/zigbee
5